PROBLEM POSSIBLE CAUSE SOLUTION
The light does not
work.
Not plugged in. Plug the cooler in.
The circuit breaker tripped
or a blown fuse.
Check the breaker and/o r fuses.
The light button is “OFF”.
Press to turn the light ON.
Vibrations.
The cooler is not le vel ed. Check to assure that the cooler is level.
The bottles are vibrating.
Make sure the bottles don
’
t touch each
others.
There is an object under the
cooler.
Remove the object u nder the cooler.
The cooler seems to
make too muc
h
noise.
The cooler is not le vel . Level the cooler.
Normal noise from the flow
of the refrigerant
The rattling noise may come from the flow
of the refrigerant, which is normal. As each
cycle ends, you may hear gurgling sounds
caused by the flow of refrigerant in your
cooler. Contraction and expansion of the
inside walls may cause popping and
crackling noises.
The door will not
close properly.
The cooler is not le vel . Level the cooler.
The door was reversed an d
not properly instal
led.
Re-install the door properly.
The gasket is dirty. Clean the door gasket.
The shelves are out of
position.
Place the shelves properly.
Moisture build up on
interior or
exterior of the
Beverage cooler.
This is normal during high
humidity periods.
Lower the room humidity.
This is normal in high
temperature environment.
Move the cooler to a cooler place, and avoi d
heat and sunlight.
Prolonged or frequent door
openings.
Open the door less often.
The door does not seal
compl
etely.
Check door gaskets f or proper seal.
Error Code:
E1-E2-E3-E4-E7-E8
A sensor has fail ed. Contact the customer service
To Next Page
Loading...
General