Tactical Momentary Illumination
Half press and hold the Tail Switch to turn on the light momentarily. Release to turn it off.
On / Off
On: When the light is off, press the Tail Switch until a click sound is heard to turn it on.
Off: When the light is on, press the Tail Switch until a click sound is heard to turn it off.
Brightness Levels
When the light is on, short press the Mode Button to cycle through the following brightness levels: ULTRALOW –
LOW – MID – HIGH – TURBO.
(This access has memory function. When reactivated, the flashlight will automatically access the previous memorized
brightness level.)
Direct Access to TURBO
When the light is off, press and hold the Mode Button to access TURBO momentarily. Release to turn it off.
When the light is on, long press the Mode Button to access TURBO directly. Short press the Mode Button to
return to the previous brightness level, or it will automatically return to the previous brightness level if there is no
operation in 30 seconds.
Special Modes (BEACON / SOS)
When the light is off, triple press the Mode Button to access the BEACON Mode.
When the BEACON Mode is on, long press the Mode Button each time to switch between SOS and BEACON.
When either special mode is on, short press the Mode Button to turn off the light.
Remote Switch
As Illustrated, plug in the cable part of the RSW2i to the USB port and clip to fasten the cable on the tail cap.
Tactical Momentary Illumination
When the light is off, press and hold Button B to turn it on momentarily. Release to turn it off.
On / Off
On: When the light is off, short press Button A to turn it on.
Off: When the light is on, short press Button A to turn it off.
Brightness Levels
When the light is on, short press Button B to cycle through the brightness levels.
Direct Access to TURBO
When the light is on, long press Button B to access TURBO directly. Short press Button B to return to the previous
brightness level, or it will automatically return to the previous brightness level if there is no operation in 30 seconds.
STROBE READY™
When the light is off, press and hold Button A to access the STROBE Mode. Release to return it off.
When the light is on, long press Button A to access the STROBE Mode. Short press Button B to return to the
previous status, or short press Button A to turn off the light.
To Next Page
Loading...
Need help?
General