25
4. By measuring the length, width and height, the device is able to calculate the volume (m
3
) of the measured
structure.
In order to perform function:
a) Start the laser rangender
b) Press the measurement mode selection button (2) four times for the capacity calculation mode
c) Press the MEAS measurement button and device power on switch (1) twice to make a measurement
5. Pythagoras function is a mode that allows you to calculate the side, for one or two rectangular triangles,
based on two measurements.
In order to perform function:
a) Start the laser rangender
b) Press the measurement mode selection button (2) ve times, for the Pythagoras function for one triangle
c) Pressing the measurement mode selection button (2) six times, for the Pythagoras function for two
triangles
d) By pressing the MEAS measurement button and device power on switch (1) twice, the measurement will
be carried out
6. The Min - Max function is a mode showing the highest and lowest value that resulted
from the measurement at the moment.
In order to perform function:
a) Start the laser rangender
b) Press and hold the MEAS measurement button and device power on switch (1) for about 3s,
for the Minimum / Maximum function
c) Press the MEAS measurement button and device power on switch (1) twice to make a measurement
To Next Page
Loading...