- 15 -
4.3.2 Connecting the network cable (Network board J3)
① Connect network lines as follows (pay attention to PIN numbers):
Schematic
Housing Cable
PIN No Feature
1 TXP
2 TXN
3 RXP
RJ45, 8PIN UTP
6 RXN
4.3.3 Connecting the power cable
Connect 12V adapter to Relay Board J4.
Connect 5V adapter ro Main Board J3
'NOTICE : When you connect extend cable, make sure the
polarity(+, -) are correct'
4.3.4 Wiegand output (Main board J5)
Check if the external device is pull up. If it is not, connect J16 and
J17.
J5 Connection
PIN Number Function
1 GND
2 Wiegand 1
3 Wiegand 0
4 +5VDC
To Next Page
Loading...
