4
IMPORATNT! READ this BEFORE installing!
Warranty clarifications
1. WATER DAMAGES TO YOUR HS4 AMPLIFIER, ARE NOT COVERED BY THE PRODUCT’S
WARRANTY:
Our engineering team designed the HS4 amplifier’s chassis to be Marine rated. However, we
strongly advise to install it where it’s protected from water/mud at all times. The sealed
structure is designed and constructed to protect the amplifier IN CASE it accidently gets wet,
but it is your responsibility to limit the amp’s exposure to water:
• Install the amplifier in a dry area where water and mud can’t reach it
• Do not clean the amplifier with high pressure or regular water hose. If needed, cover it
while washing your vehicle
2. BURNT VOICE COILES ARE NOT COVERED BY THE PRODUCT'S WARRANTY
We desgined our amplifier to be very powerful. If its gains are set too high (clockwise), it may
cause irreversible damage to the speaker’s voice coils. Exactly for that reason we pre tuned
each and every amplifier to optimaly power the various NUTV5 series audio systems.
Under or overpowering your speakers might cause them thermal (burnt voice coil) and/or
mechanical failure (torn surrounds or spiders). And these damages are not covered by your
warranty.
Below you will find our recommended factory gains and crossover settings for each NUTV5
series audio systems (wrong font):
NUTV5 (Two N5 tower speakers)/ NUTV5-S (Two N5 tower speakers and a Subwoofer)/ NUTV5-
S QUAD – (Four N5 tower speakers and a Subwoofer)
NOTE: Rear’s crossover is set on LPF (low pass) for the NSUB subwoofer
Front’s crossover is set on FULL (full range) for tower speakers
To Next Page
Loading...
