To Next PageTo Next PageWhat to do if my Noblelift Trucks load can not be lifted?
If your Noblelift Trucks won't lift a load, it might be because the load is too heavy. Ensure that the load is lighter than the maximum capacity indicated on the ID plate. Other potential causes include a discharged battery (charge it), a lifting fuse fault (check and replace if necessary), low hydraulic oil level (check and refill), or oil leakage (maintain the cylinder's sealing).
Defines the proper and intended use of the electric pallet truck.
Identifies and labels the key components of the pallet truck.
Provides detailed technical specifications and dimensions of the truck.
Explains the various safety decals and their meanings on the truck.
Details the information found on the truck's identification plate.
Lists important warnings, residual risks, and essential safety instructions for operation.
Step-by-step guide for putting the new truck into operation.
Instructions for safely lifting and transporting the pallet truck.
Procedures for safely storing or disposing of the pallet truck.
Details the essential pre-operation checks to be performed daily.
Instructions on how to properly park the truck.
Steps for safely lifting and lowering loads with the pallet truck.
Guidelines for safe driving and traveling, including on inclines.
Explains how to steer the pallet truck using the tiller.
Details the various braking methods and checks for the truck.
Instructions on what to do if the truck experiences any malfunctions.
Actions to take in emergency situations, like tipping or off-dock events.
Steps to ensure accurate weight measurements are taken.
Explains the calculation of net, tare, and gross weights.
Describes common error messages and their potential causes/solutions.
Details how to use the zero and tare functions on the weighing terminal.
Explains how to use the summation feature to total multiple weights.
Information on the optional printer, its specifications, and function.
Instructions for replacing the paper roll in the optional printer.
How to perform checks on the indicator buttons and display.
Procedure for setting the default units of measurement.
Explains how to adjust the backlight settings for the indicator display.
Step-by-step guide for calibrating the weighing terminal for accuracy.
Detailed instructions on how to replace the truck's battery.
Describes the layout and functions of the indicator's operation panel.
Step-by-step guide for installing the sensors for the weighing system.
Explains the various functions assigned to the buttons on the indicator.
Introduces the pin-code panel system for security and operation.
Lists the key operating parameters for the pin-code panel.
Details how to use passwords for truck operation and security.
Step-by-step replacement of the truck's battery.
Explains how to interpret the battery charge level indicators.
Provides instructions for safely charging the truck's battery.
A detailed checklist of maintenance tasks and their recommended intervals.
Identifies all points on the truck that require lubrication.
Instructions for checking and refilling the hydraulic oil.
Guidance on inspecting and checking the electrical fuses.
Provides common faults, their possible causes, and solutions.
Addresses specific issues like tiller position and moving a non-operational truck.
Presents the electrical schematic for the truck, without speed reduction.
Lists and describes the electrical components used in the truck's diagrams.
Shows the electrical schematic including speed reduction on curves.
Illustrates the hydraulic system of the pallet truck.
General
