To Next PageTo Next PageWhat to do if the Nobles Speed Scrub Rider horn beeps 8 times?
If the horn on your Nobles Scrubber repeatedly beeps eight times, the emergency stop button is likely engaged. To resolve this, reset the emergency stop button.
Why does the Nobles Speed Scrub Rider Scrubber horn beep 9 times?
The horn on your Nobles Scrubber beeps nine times repeatedly because the ON/OFF key switch is turned on while the battery charger is plugged into the machine. Unplug the battery charger before starting the machine to stop the beeping.
Why does my Nobles Speed Scrub Rider Scrubber beep twice?
Your Nobles Scrubber beeps twice because the propel pedal is depressed without the operator sitting in the seat. Make sure you are sitting in the seat when operating the machine.
What to do if Nobles Scrubber horn beeps 4 times?
If the horn on your Nobles Scrubber repeatedly beeps four times, it means the ON/OFF key switch was turned on while the propel pedal was engaged. Release the propel pedal before turning the key on.
Critical instructions for safe operation and understanding the manual before use.
Hazards associated with battery hydrogen gas, explosion, and fire risks.
Risks of explosion or fire from flammable materials in tanks or picked up.
Notice regarding chemicals known to cause cancer or reproductive harm.
Procedures before leaving, servicing, or handling the machine.
Guidelines for safely loading and unloading the machine onto transport vehicles.
Warning label regarding battery hydrogen gas, explosion, and fire hazards.
Labels warning about flammable materials causing explosion or fire.
Overview of buttons, indicators, and controls on the operator's panel.
A checklist of items to inspect before operating the machine.
Troubleshooting steps for issues with water pickup and trailing water.
Causes and remedies for the vacuum fan not operating.
Troubleshooting common problems with the FaST system not operating.
Troubleshooting blinking or red indicator lights for ec-H2O NanoClean models.
Troubleshooting issues with older ec-H2O models' indicator lights and water flow.
General advice for maintaining battery life and safe charging practices.
Procedure for checking and topping up electrolyte levels in wet batteries.
How to verify and set the on-board charger for the correct battery type.
Detailed steps for charging batteries using the integrated on-board charger.
Explanation of error codes displayed by the on-board charger.
Detailed procedure for removing, rotating, and installing cylindrical brushes.
Procedure for replacing water and air filters in the FaST detergent injector.
Step-by-step guide for replacing the water conditioning cartridge.
Step-by-step guide for removing and installing rear squeegee blades.
Guidelines for safely loading, securing, and transporting the machine.
General
