Nobles STRIVE RIDER User Manual

OPERATION
18
Nobles Strive Rider (09--06)
DRAINING AND CLEANING SOLUTION TANK
1. Hold the solution tank hose upward, remove the
cap and slowly lower hose to drain (Figure 37).
FIG. 37
2. T ilt the recovery tank back and remove the solution
tank cover to access the solution tank. Clean the
solution tank (Figure 38). Make sure the recovery
tank is empty before tilting.
FIG. 38
CHARGING BATTERIES
ATTENTION: To prolong the life of the batteries
only recharge the batteries if the machine was
used for a total of 30 minutes or more. Do not leave
batteries discharged for lengthy periods.
W ARNING: Fire Or Explosion Hazard.
Batteries Emit Hydrogen Gas. Keep Sparks And
Open Flame Away. Keep Battery Compartment
Open When Charging.
FOR SAFETY: When servicing batteries, wear
protective gloves and eye protection when
handling batteries and battery cables. Avoid
contact with battery acid.
BATTERY CHARGER SPECIFICATIONS
S CHARGER TYPE:
-- FOR WET (Lead acid) BATTERIES
S OUTPUT VOLTAGE - 24 VOLTS
S OUTPUT CURRENT - 30 AMPS
S AUTOMATIC SHUTOFF CIRCUIT
S FOR DEEP CYCLE BATTERY CHARGING
1. Park the machine on a flat, dry surface and turn the
key off. Make sure the area is well ventilated.
2. T ilt the seat forward for ventilation (Figure 39). Use
the seat stand to hold the seat up.
FIG. 39
3. Check the battery fluid level before charging (Figure
40). The fluid level should slightly cover the battery
plates. Add distilled water if low. DO NOT
OVERFILL. The fluid will expand and may overflow
when charging.
FOR SAFETY: When servicing batteries, wear
protective gloves and eye protection when
handling batteries and battery cables. Avoid
contact with battery acid.
Battery Plates
FIG. 40
4. Connect the charger’ s AC power supply cord into a
properly grounded wall outlet.

Nobles STRIVE RIDER Specifications

Vacuum System

vacuum fan airflow	66.5 CFM
vacuum system airflow - actual ReadySpace	48 CFM
vacuum system airflow - actual Extraction	32 CFM
vacuum motor airflow – max	70-inch/ 1780 mm
vacuum motor sealed water lift	70.5 inches

Scrubbing System

brush motor power	0.54 hp / 0.40 kW
roller/brush speed	270 rpm
down pressure ReadySpace - standard	104 lbs
down pressure ReadySpace - heavy	152 lbs
down pressure Extraction - standard	32 lbs
down pressure Extraction - heavy	84 lbs

Solution Delivery System

solution tank capacity	32 gal / 121 L
pump max rated pressure	250 psi
working pressure at spray tips ReadySpace	30 psi
working pressure at spray tips Extraction	52 psi

Recovery System

recovery tank capacity	28 gal / 106 L

Power System

battery capacity	335 AH (@20hr discharge rate)
maximum continuous run time	3.0 hours

Transport Drive System

ReadySpace propel speed - variable	150 fpm / 46 mpm
Extraction propel speed – variable	75 fpm / 23 mpm
propel speed reverse - variable	175 fpm / 53 mpm
propel motor power	1.1 hp / 0.85 kW

Productivity

theoretical max coverage - ReadySpace	13, 000 ft[2] / hr / 1, 208 m[2] / hr
estimated coverage - ReadySpace	10, 000 ft[2] / hr / 929 m[2] / hr
theoretical max coverage - Extraction	7, 500 ft[2] / hr / 697 m[2] / hr
estimated coverage - Extraction	5, 000 ft[2] / hr / 465 m[2] / hr

Weight and Dimensions

length	61.5 in / 1560 mm
width	31.5 in / 800 mm
height	52 in / 1325 mm
net weight with batteries	1225 lb / 560 kg