To Next Page

To Previous Page

interfere with pacemakers or other medical devices. Consult with your physician prior to use if you have any medical device including pacemakers. If you suspect

the product is interfering with a medical device, stop using the product immediately and consult your physician. Medical Conditions. If you have any medical

condition that you believe could be aected by product, including but not limited to; seizures, blackouts, eyestrain or headaches, consult your physician prior to use

of product. Cleaning. Power o the product before attempting any maintenance or cleaning. Clean and dry product immediately if it comes in contact with liquid or

any type of contaminant. Use a soft, lint-free (microﬁber) cloth. Avoid getting moisture in openings. Explosive Atmospheres. Obey all signs and instructions. Do not

operate product in any area with a potentially explosive atmosphere, including fueling areas or areas which contain chemicals or particles such as grain, dust or metal

powders. High-Consequence Activities. This product is not intended for use where the failure of the product could lead to injury, death or severe environmental

damage. Radio Frequency Interference. Product is designed, tested, and manufactured to comply with regulations governing radio frequency emissions. Such

emissions from the product can negatively aect the operation of other electronic equipment, causing them to malfunction. Model Number: Genius 2D This device

complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device

must accept any interference received, including interference that may cause undesired operation. NOTE: This equipment has been tested and found to comply with

the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference

when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used

in accordance with the instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause

harmful interference in which case the user will be required to correct the interference at his/her own expense.

Charging Modes.

The Genius 2D has two (2) automatic modes, and will begin charging when both the battery and power are connected. Do not operate the charger until you conﬁrm

the Genius 2D charger is compatible with your battery type and voltage. Below is a brief description:

How To Use

Mode Explanation

12V NORM

Standby

No Power

14.5V | 2000mA | Up To 40Ah Batteries | Maintain all sizes

The charger is connected to AC power but no battery is detected, and the charger is not charging. Energy Save is activated during this mode,

drawing microscopic power from the electrical outlet.

For charging 12-volt Wet Cell, Gel Cell, Enhanced Flooded, Maintenance-Free, Calcium batteries and AGM.