SIM related faults
Insert SIM card fault
Troubleshooting flow
The hardware of the SIM interface from UEMCLite (D2200) to the SIM connector (X2700) can be tested without
a SIM card. When the power is switched on the phone first check for a 1.8V SIM card and then a 3V SIM card.
The phone will try this four times, where after it will display ”Insert SIM card”.
Figure 15 Insert SIM card fault
RM-258; RM-259
Baseband Troubleshooting Instructions
Issue 1 COMPANY CONFIDENTIAL Page 3 –15
Copyright © 2007 Nokia. All rights reserved.
To Next Page
Loading...
