Nokia 3109 classic - Settings; USB data cable and Call settings

USB data cable
You can use the USB data cable to transfer data between the device and a
compatible PC or a printer supporting PictBridge. You can also use the USB data
cable with Nokia PC Suite.
To activate the device for data transfer or image printing, connect the data
cable. Confirm "USB data cable connected. Select mode." and select from the
following options:
• Nokia mode — to use the cable for PC Suite
• Printing & media — to use the device with a PictBridge compatible printer
or with your compatible PC
• Data storage — to connect to a PC that does not have Nokia software and
use the device as a data storage device
To change the USB mode, select Menu > Settings > Connectivity > USB
data cable and the desired USB mode.
Call
Select Menu > Settings > Call and from the following options:
• Call divert — to forward your incoming calls (network service). You may not
be able to forward your calls if some call restriction functions are active. See
"Security," p. 61.
• Voice clarity — Select Active to enhance speech intelligibility especially in
noisy environments.
• Anykey answer — Select On to answer an incoming call by briefly pressing
any key, except the power key, the left and right selection keys, or the end
key.
• Automatic redial — Select On to make a maximum of 10 attempts to
connect the call after an unsuccessful call attempt.
• Speed dialling — Select On to dial the names and phone numbers assigned
to the number keys 2 to 9 by pressing and holding the corresponding number
key.
Settings
58
Cyan
Cyan
Magenta
Magenta
Yellow
Yellow
Black
Black
file:/D:/temp/overmode/GUID-1CEEB162-7A20-44BD-B810-5A0A723017F0.20070508154818636.en1178629717662/en/1/GUID-99309606-A5AF-4368-A45B-
BF2275776152.xml Page 58 May 8, 2007 4:09:52 PM