Nokia FastMile 4G Receiver Product Overview ANSI safety guidelines
Issue: 01 DRAFT 3TG-00386-ABAA-TCZZA 23
DRAFT
4.2.1 EMC, EMI, and ESD compliance
The Nokia FastMile 4G Receiver equipment complies with the following EMC, EMI,
and ESD requirements:
• Federal Communications Commission PART 15-RADIO FREQUENCY DEVICES
Subpart C-INTENTIONAL RADIATORS Title 47 CFR Part 15. Part 15.247, Part
15.255
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user
is encouraged to try to correct the interference by one or more of the following
measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the
receiver is needed.
• Consult the dealer or an experienced radio/TV technician for help.
4.2.2 Equipment safety standard compliance
The Nokia FastMile 4G Receiver equipment complies with the requirements of:
• UL62368-1, Outdoor ONTs to “Communication Service Equipment” (CSE) and
Indoor ONTs to Information Technology Equipment (ITE)
• Information Technology Equipment- Safety - Part 22 Equipment to be installed
Outdoors
• UL 60950-22
4.3 Electrical safety guidelines
This section provides the electrical safety guidelines for the Nokia FastMile 4G
Receiver equipment.
To Next Page
Loading...
