Nokia 4G04-A - Page 54

Nokia FastMile 4G Receiver Product Overview
54 3TG-00386-ABAA-TCZZA Issue: 01 DRAFT
DRAFT
The signal strength LEDs can be activated by pressing the measurement button on
the side of the Compact multi-band models of the Nokia FastMile 4G Receiver.
Figure 19 shows the location of the measurement button.
Figure 19 Location of the measurement button
28885
The signal strength LEDs act as a set to indicate the LTE signal strength detected
by the Nokia FastMile 4G Receiver. For example, if the signal strength is fourth level,
then LEDs 1, 2, 3, and 4 are lit. The Nokia FastMile 4G Receiver Installation Guide
provides more information about the signal strength LEDs.
LEDs
Me
asu
rement
bu
tton