The display indicators
11
©
2001 Nokia Mobile Phones. All rights reserved.
Key in the PIN code of the SIM card used
(factory setting: SIM card of the handset),
which is displayed as ****, and press M
(OK), see “4-3-5 Change access codes” on
page 29.
Note: If you enter an incorrect PIN three times in succession,
the card is blocked and you have to re-enter the PIN using the
personal unblocking key number (PUK), see “Access codes” on
page 35.
Note: If your SIM card is lost or stolen, immediately inform your
network operator or service provider to block the card and thus
prevent any unauthorised use at your expense. As a rule, you will
have to specify your name, the SIM card number and your sub-
scriber‘s number.
If the handset asks for a security code
Key in the security code, which is displayed
as *****, and press M (OK), see “About
labels on your car phone” on page 8.
Note: If you take out the SIM card while the
phone is in operation, information could be
lost.
The display indicators
The indicators described below are shown
when the car phone is ready for use, and no
characters have been entered by the user.
This is also called a “clear display”.
Operator Indicates which cellular network
the car phone is currently being used in.
Depending on your SIM card, the name of the ser-
vice provider may be shown in the next line.
½ Shows the signal strength of the cellular network at
your current location: the higher the bar, the stron-
ger the signal.
10:12 Shows the time.
¼ Shows that you have received a short message.
‰ Notifys divert of all voice calls.
² Shows that the phone is in silent mode.
¹
Enter PIN code
of handset SIM
****
OK
¹
Security
code
*****
OK
10:12
Operator
½
Menu
To Next Page
Loading...
