8 Clock
32
©
2001 Nokia Mobile Phones. All rights reserved.
8 Clock
8-1 Alarm clock
The phone can be set to ring as an alarm at a specified time. The
alarm clock uses the time format set for the clock: a 12-hour cy-
cle or a 24-hour cycle.
Note: If the phone is switched off, the alarm clock will not work.
In this menu, you can set the alarm time or select On to change
the alarm time or Off to turn off the alarm clock.
When the set alarm time expires
The timer alert tone corresponds to the ringing volume setting.
However, only a beep is heard, if you have selected Off or Beep
once
in the Tones menu.
When the phone alarm goes off, the message
Alarm! is shown
and the lights flash. If you let the phone alarm run for a minute
or if you press M (Snooze), the alarm stops for a few min-
utes and then re-sumes ringing. Press any other key to stop the
alarm.
8-2 Clock settings
The phone is provided with a real-time clock. Since the phone
has no power backup, you may need to set the time again if the
car battery is flat or has been removed.
In this menu, you can Show / Hide clock, Set the time or se-
lect the 12-hour or 24-hour Time format.
9 Tones
9-1 Incoming call alert
This menu function allows you to select how the phone notifies
you of an incoming call. Available options are Ringing, Ascend-
ing, Ring once, Beep once
or Off if no ringing tone is to be
heard.
Note: If the phone is set to Off, no ringing tone, message alert
tone, keypad tone or warning tone will be sounded.
9-2 Ringing tone
You can select any of the ringing tone types available in this
menu.
9-3 Ringing volume
A ringing tone is set off when there is an incoming call. This
menu function allows you to select any of the ringing volume
levels available. The ringing tone volume set also affects the
volume of the message alert tone.
To Next Page
Loading...
