Nokia 6120 - Calling Card

24
display if their name and number has been stored in the
phone book (see Phone book on page 50) or if the
wireless network supports it.
&DOO or &DOO0FDOOHU ,' XQDYDLODEOH will display when the
wireless network doesnt recognize the calling number.
Also,
&DOO0FDOOHU ,' EORFNHG may display if the calling party
has blocked caller ID.
Calling card
If you wish to use a calling card for
long distance calls, you must first
store your calling card information
into your phone. Your phone can
store up to four calling cards.
Programming a calling card
1) Press
0HQX 4 1 3 (6HWWLQJV - &DOO VHWWLQJV - &DOOLQJ FDUG)
(For details on how to work the Menu, see page 13)
2) Press
W or V to desired calling card, press 2SWLRQV
3) Press W or V to (GLW, press 2.
4) Enter security code and press 2.
5) Press 6HOHFW at 'LDOLQJ VHTXHQFH. Select the dialing
sequence your card uses (use chart below), press
W or V to choose sequence, then press 6HOHF W
Note: The order of the following steps may vary, depending on
which dialing sequence your card uses.
6) Enter access number (usually the 1-800 number
listed on the back of the calling card), press
2.
Note: You can also retrieve the access number from your phone
book if it has already been stored. Simply press
6HD UF K
, then
W
or
V
to find the number.
7) Enter card number and/or PIN, press 2.1 Press 2.
again at
6DYH FK DQJH V?
8) Press
W or V to &DUG QDPH and press 6HOHFW. Enter
card name using your phones keypad, press
2..