21
Enhanced voice dialing
You can say the name saved in the contact list of the phone to make a phone call.
Voice commands are not language-dependent.
Note: Using voice tags may be difficult in a noisy environment or during an
emergency, so you should not rely solely upon voice dialing in all circumstances.
1. In the standby mode, press and hold the right selection key or press and hold
the volume down key. A short tone is played, and Speak after the tone is
displayed.
2. Say the voice command clearly. If the voice recognition was successful, the
phone plays the voice command of the match on the top of the list. If the result
is not the correct one, scroll to another entry.
Using voice commands to carry out a selected phone function is similar to
voice dialing. See Voice commands in ”Phone settings”, page 35.
■
Answer or end a call
To answer an incoming call, press the call key, or open the phone. To end the call,
press the end key, or close the phone.
To reject an incoming call, press the end key, or close the phone. To reject an
incoming call when the phone is closed, press and hold a volume key.
To mute the ringing tone, press a volume key when the phone is closed, or select
Silence when the phone is open.
Call waiting
To answer a waiting call during an active call, select Answer. The first call is put on
hold. To end the active call, press the end key. To switch back to the first call
without ending the second call, select Options > Swap.
To activate the call waiting function, see ”Call settings”, page 34.
■
Options during a voice call
Many of the options that you can use during a call are network services. For
availability, contact your service provider.
During a call, select Options and from the following:
Call options are Mute or Unmute, Contacts, Menu, Lock keypad, Record,
Loudspeaker or Handset.
Network services options are Answer or Decline, Hold or Unhold, New call, Add to
conference, End call, End all calls, and Touch tones.
To Next Page
Loading...
