PAGE 13 (19) Approved 1.0
Nokia Mobile Phones Customer Care E&A
SQX 00444-en MWy
Technical Services, Repair Concepts Confidential 25.09.2002
Take a clean cloth and press the LCD from the LCD
Frame.
Bend the frame a bit, shift the UI Board Module to
the right and then pull it up.
To remove the DC Jack, place tweezers between the
spring contacts and under the jack. You’ll need to
use additional force to pull the jack upwards.
Remove the Vibra Motor with the rubber and pull it
from its guidance.
Volume Key and the Infrared Window can be easily
removed with your fingers. The Power Key has to be
unlocked on the lower side first.
Unlock Antenna on both sides with SRT-6.
Antenna Pogo Pins can be removed by pushing with
Torx driver through the C-Cover.
If there is a need to change the Release Button, also
SRT-6 can be used.
Service Manual 7210/6610 Level 1&2 Copyright 2002 © Nokia Corporation
To Next Page
Loading...
