Copyright © 2003 Nokia. All rights reserved.
76
Screen saver
A digital clock screen saver is used for power saving in standby mode. It activates
when no function of the phone has been used for a certain length of time. Press
any key to deactivate the screen saver. The screen saver is also deactivated when
the phone is out of the network coverage area.
Press Menu and select Settings, Display settings, and Screen saver timeout. Select
the length of time after which the digital clock display will be activated. The
timeout can vary from 5 seconds to 60 minutes.
Note that the screen saver overrides all graphics and texts that are on the display
in standby mode.
■ Tone settings
Press Menu, and select Settings and then Tone settings. You can find the same
settings in the Profiles menu, see Profiles on page 48. Note that the settings you
make, change the settings in the active profile.
Select Incoming call alert to select how the phone notifies you of an incoming
voice call. The options are Ringing, Ascending, Ring once, Beep once and Off.
Select Ringing tone for incoming voice calls. To select ringing tones that have
been saved in the Gallery, select Open gallery from the ringing tone list.
Select Ringing volume and Vibrating alert for incoming voice calls and messages.
The vibrating alert does not work when the phone is connected to a charger, a
desktop stand, or a car kit.
To Next Page
Loading...
