Quick guide
4
9 Write the current time using the 24-hour format hh:mm, for example
17:25, and press OK.
10 Enter your contact information in the user data card and press OK.
The first start-up is now completed.
After the start-up, do not immediately remove the battery, as the battery
charges the backup battery that supplies power to the real-time clock of the
communicator.
To charge the battery
1 Connect the charger lead to the bottom of the communicator:
2 Connect the charger to the proper voltage AC wall outlet. While charging
is in progress, the battery charge indicator scrolls on the display.
To use the battery
Use only batteries approved by the communicator manufacturer and recharge
the battery only with the chargers approved by the manufacturer. With
approved chargers and accessories, the battery can be charged continuously.
The battery need not be fully discharged before recharging. When a charger is
not in use, disconnect it from the power source. Do not leave the battery
connected to a charger for longer than a week, since excessive charging may
shorten its life. If left unused, a fully charged battery will discharge itself over
time.
The battery can be charged and discharged hundreds of times, but it will
eventually wear out. When the operating time (talk-time and standby time) is
noticeably shorter than normal, it is time to buy a new battery.
Figure 5
Note: The communicator can
be used normally during
charging.
To Next Page
Loading...
Need help?
General
