Nokia A032 Getting Started Guide

8
Nokia A032 Getting Started
Rear panel
After unpacking the unit, look at the rear panel
and identify the various connectors:
•
Power connector – This is where you connect
the power unit. Only use the power unit
supplied with the Nokia A032.
•
RJ45 (10baseT) connector – Use this to make
the LAN connection.
•
PCMCIA slot – This is where you insert the
Nokia C111 Wireless LAN Card.
•
Serial port – The serial port can be used for
a number of functions depending on the
application:
• Modem connection for Internet access
• Management functions
• Diagnostics
• Downloading new firmware.
Note: The Nokia A032
has no integral power
switch – switch on
and off at the wall
outlet or by removing
the power connector
from the rear of the
unit.
PCMCIA
slot
serial
port
RJ45
(10baseT)
connector
power
connector
WARNING: Use of a
power unit other than
that supplied with the
Nokia A032 may result
in unreliable operation
or permanent damage
to the unit and will
void the warrantee.

Nokia A032 Specifications

General

Brand	Nokia
Model	A032
Category	Wireless Access Point
Language	English