1. Connect the respective wires of the power cable CA-153P to the car battery
and ignition sense (if available). Connect the car radio mute wire (if available)
to the car radio.
2. Plug the power cable to the respective connector on the hands-free unit.
3. Connect the loudspeaker SP-3 to the respective connector on the hands-free
unit.
4. Connect the stereo outputs of the hands-free unit to the AUX input of the
car radio. Use an appropriate cable specific to your car radio (this cable is
not supplied with the car kit).
5. Connect the external input device CU-10 and the microphone MP-2 to the
respective connectors on the hands-free unit.
6. To charge a compatible Nokia mobile phone through the car kit, connect
one end of the supplied charging cable CA-134 to the hands-free unit and
the other end to the 2.0 mm (0.08 inch) charging connector of the phone.
7. Switch on the car kit, press the wheel in the standby mode, and select
Settings > Audio > Music output > Automatic detection. Alternatively, if the
music is to be played back through an external loudspeaker (such as the
SP-3), select Mono speaker instead of Automatic detection.
For connection of the line-out of the hands-free unit to the line-in of the radio
a radio-specific cable is needed.
Usage of an external loudspeaker for telephony
and the car stereo system for music
Please note: car accessories must be installed or repaired by qualified professionals only.
Carefully read the User Guide and Installation Guide for each system to be installed.
15
Installation guidelines
14
© 2008 Nokia.
All rights reserved.
Options of installation, III
To Next Page
Loading...
