Installation
10
• Remember that modern automotive systems include on-
board computers where key vehicle parameters are stored.
Improper disconnection of the car battery may cause loss
of data, necessitating extensive effort for re-initialisation
of the system. If you have any concerns, contact your car
dealer before any installation work is done.
• Do not wire Advanced Car Kit CK-7W equipment to the
high-voltage lines of the ignition system.
• All equipment must be mounted so that it does not
interfere with the operation of the vehicle.
• Your service technician may be able to provide you with
information on alternatives for mounting the equipment
suitably in your vehicle without requiring boreholes.
• The mount for the phone holder is to be fixed to the
dashboard or to any other location in the cockpit area
where the display is clearly visible for the user but does not
impair control or operation of the vehicle. The keypad
should be within easy reach of the driver.
• Make sure not to impact the steering or braking systems or
other key systems essential for proper operation of the car
when installing Advanced Car Kit CK-7W equipment.
Check to make sure that deployment of the airbag is not
blocked or impaired in any way.
• Do not smoke when working on the car. Make sure that
there is no source of fire or flame nearby.
• Take care not to cause damage to electrical cables, fuel or
brake lines or safety equipment during installation work.
• RF signals may affect improperly installed or inadequately
shielded electronic systems in motor vehicles (e.g.
electronic fuel injection systems, electronic anti-skid
braking systems, electronic speed control systems, airbag
systems). Should you note a fault or change in the
operation of such a system, contact your car dealer.
9230221_CK-7_1_en.fm Page 10 Thursday, August 12, 2004 4:13 PM
To Next Page
Loading...
