Installation
16
An additional relay can be used to enable the car radio to be muted.
When a call is accepted, the Advanced Car Kit switches the yellow
line (MUTE) to ground, muting the car radio. When the call is ended,
the yellow line is separated from ground and the car radio is
unmuted.
• Connect the blue wire to the IGNS line of the car using the 1A fuse
supplied.
Some vehicles do not come with an IGNS connection. This line is not
necessary for operation of the Advanced Car Kit; the blue wire can be
left unconnected. However, in this case, the Advanced Car Kit does
not switch off automatically when the ignition is turned off. To
prevent accidental draining of the car battery, the Advanced Car Kit
automatically switches off after two minutes unless a mobile phone
is connected over Bluetooth wireless technology or the data cable.
• Connect the red wire to the positive terminal of the 12V car battery
using the 2A fuse supplied.
The four-pin plug of the cable set is plugged into the "DC" port of the
handsfree unit.
Data cable
The data cable connects the handsfree unit with a compatible mobile
phone, i.e. via the phone holder.
Plug one end of the cable into the "PHONE" socket in the handsfree unit
and the other into the phone holder.
If the Advanced Car Kit is to be used only with Bluetooth wireless
technology, the data cable does not need to be connected.
■ Function test
After your Advanced Car Kit has been installed, it needs to be checked to
ensure that it is working properly. When testing the operation of the
equipment, also check that it has been mounted so that it in no way
impairs the driver during operation of the vehicle.
9230221_CK-7_1_en.fm Page 16 Thursday, August 12, 2004 4:13 PM
To Next Page
Loading...
