Installation
7
• Your service technician may be able to provide you with information
on alternatives for mounting the equipment suitably in your vehicle
without requiring boreholes.
• The mount for the phone holder is to be fixed to the dashboard or
to any other location in the cockpit area where the display is clearly
visible for the user but does not impair control or operation of the
vehicle. The keypad should be within easy reach of the user.
• Make sure not to impact the steering or braking systems or other
key systems essential for proper operation of the car when installing
Advanced Car Kit CK-7W equipment. Check to make sure that
deployment of the airbag is not blocked or impaired in any way.
• Do not smoke when working on the car. Make sure that there is no
source of fire or flame nearby.
• Take care not to cause damage to electrical cables, fuel or brake
lines or safety equipment during installation work.
• RF signals may affect improperly installed or inadequately shielded
electronic systems in motor vehicles (e.g. electronic fuel injection
systems, electronic anti-skid braking systems, electronic speed
control systems, airbag systems). Should you note a fault or change
in the operation of such a system, contact your car dealer.
• Ensure that cables are placed so that they will not be subjected
to mechanical wear and tear (e.g. not laid under car seats or over
sharp edges).
CK-7W_ENv1_9230761.book Page 7 Friday, March 26, 2004 11:17 AM
To Next Page
Loading...
