Installation
13
• Connect the blue wire to the IGNS line of the car using the
1A fuse supplied.
Some vehicles do not come with an IGNS connection. This line is not
necessary for operation of the Advanced Car Kit; the blue wire can
be left unconnected. However, in this case, the Advanced Car Kit
does not switch off automatically when the ignition is turned off.
To prevent accidental draining of the car battery, the Advanced Car
Kit automatically switches off after two minutes unless a mobile
phone is connected over Bluetooth wireless technology or the
data cable.
• Connect the red wire to the positive terminal of the 12V car battery
using the 2A fuse supplied.
The four-pin plug of the cable set is plugged into the "DC" port of
the handsfree unit.
Data cable
The data cable connects the handsfree unit with a compatible mobile
phone, i.e. via the phone holder.
Plug one end of the cable into the "PHONE" socket in the handsfree unit
and the other into the phone holder.
If the Advanced Car Kit is to be used only with Bluetooth wireless
technology, the data cable does not need to be connected.
• FUNCTION TEST
After your Advanced Car Kit has been installed, it needs to be checked
to ensure that it is working properly. When testing the operation of the
equipment, also check that it has been mounted so that it in no way
impairs the driver during operation of the vehicle.
CK-7W_ENv1_9230761.book Page 13 Friday, March 26, 2004 11:17 AM
To Next Page
Loading...
