RM-632 / RM-634 / RM-699
Service Manual Level 1&2
Co nf id e nt ial | Cop y rig ht © 2011 NOKIA A ll right s reserved
10. ASSEMBLY HINTS
1) Connect the LCD connector to the engine board.
2) Use the SS-93 to carefully bend the LCD flex while
pushing the LCD carefully forward.
3) Position the top clip and carefully press down
the LCD flex.
4) Press down the clips on both sides.
5) Slide the LOCKING PLATE ASSEMBLY between the
LCD connector and the bent flex. Press down the
shown clip to lock the LOCKING PLATE ASSEMBLY.
6) Tighten the four TORX + size 6 screws to the
torque of 13 Ncm in the order shown.
To Next Page
Loading...
