Configuring multimedia messages (MMS)
16
Copyright © 2006 Nokia. All rights reserved. 
Configuring multimedia 
messages (MMS)
Note: Only devices that have compatible 
features can receive and display multimedia 
messages. The appearance of a message may 
vary depending on the receiving device. 
Before you can send or receive multimedia 
messages on your device, you must define the 
multimedia message settings. Your device may 
have recognized the SIM card provider and 
automatically configured the multimedia 
message settings. If not, contact your service 
provider.
Select Menu
→ Messag.→ Options→ Settings→ 
Multimedia message to access the multimedia message 
settings.
• Image size — Select Small or Large to scale images in 
multimedia messages. Select Original to maintain the 
original image size of multimedia messages.
• MMS creation mode — Select Restricted to have your 
device prevent you from including content in 
multimedia messages that may not be supported by 
the network or the receiving device. To receive 
warnings about including such content, select Guided. 
To create a multimedia message with no restrictions 
on attachment type, select Free. If you select Restricted, 
creating multimedia presentations is not possible.
• Access point in use — Select the default access point to 
connect to the multimedia message center. You may 
not be able to change the default access point if it is 
preset in your device by your service provider.
• Multimedia retrieval — Select Always automatic to 
always receive multimedia messages automatically, 
Aut. in home network to receive notification of a new 
multimedia message that you can retrieve from the 
message center (for example, when you are traveling 
abroad and are outside your home network), Manual to 
retrieve multimedia messages from the message center 
manually, or Off to prevent receipt of any multimedia 
messages.
• Allow anon. msgs. — Select whether you want to receive 
messages from unknown senders.
• Receive adverts — Select whether you want to receive 
messages defined as advertisements.
• Receive report — Select Yes to have the status of the 
sent message to be shown in the log (network service). 
Receiving a delivery report of a multimedia message 
that has been sent to an e-mail address may not be 
possible.
• Deny report sending — Select Yes to not send delivery 
reports from your device for received multimedia 
messages.