Configuring wireless LAN
13
Copyright © 2006 Nokia. All rights reserved.
Configuring wireless LAN
1 Select Menu→ Tools→ Settings→ Connection→
Wireless LAN to access WLAN settings:
• To have an indicator displayed when there is a
wireless LAN available in your current location,
select Show availability
→ Yes.
• To select the time interval for your device to scan for
available wireless LANs and update the indicator,
select Scan for networks. This setting is not visible
unless you select Show availability→ Yes.
2 Select Menu→ Tools→ Settings→ Connection→
Wireless LAN→ Options→ Advanced settings to access
advanced WLAN settings. The wireless LAN advanced
settings are normally defined automatically, and
changing them is not recommended. To edit the
settings manually, select Automatic config.
→ Disabled,
and define the following:
• Long retry limit — Enter the maximum number of
transmission attempts if the device does not receive
a receiving acknowledgement signal from the
network.
• Short retry limit — Enter the maximum number of
transmission attempts if the device does not receive
a clear-to-send signal from the network.
• RTS threshold — Select the data packet size at which
the wireless LAN access point device issues a request
to send before sending the packet.
• TX power level — Select the power level of your device
when sending data.
• Radio measurements — Enable or disable the radio
measurements.
• Power saving — Enable or disable power saving.
To restore all settings to their original values, select
Options
→ Restore defaults.
To Next Page
Loading...
