Nokia E7-00 - Page 30

Nokia E7-
00
RM-626
Service Manual Level 1&2
30 Confidential | Copyright © 2010 Nokia | All rights reserved Version 1.0
31) Remove the protective film. 32) Pull out and remove the HINGE PIN to release the
BASE CHASSIS ASSEMBLY.
33) Tighten these two TORX + size 4 screws to the
torque of 5 Ncm in the order shown.
34) Tighten these two TORX + size 4 screws to the
torque of 12 Ncm in the order shown.
35) Remove the DUMMY KEYMAT with the tweezers
and close the device.
36) Move the two coaxial cables to the side, so that
they are not damaged while assembling the ENGINE
BOARD.