Nokia E7-00 - Page 31

Nokia E7-
00
RM-626
Service Manual Level 1&2
31 Confidential | Copyright © 2010 Nokia | All rights reserved Version 1.0
37) Connect the UI FLEX connector. Be careful not to
damage connector or any nearby components.
38) Lower down the ENGINE BOARD and check that
the guiding pin is aligned correctly.
39) Check also the second guiding pin on the other
side of the engine board.
40) Use the SS-231 and the same procedure as
before to connect the BLACK COAX CABLE connector to
the connector marked with a letter B.
41) Use the SS-231 to connect the WHITE COAX CABLE
connector to the connector marked with a letter W.
42) Place the ENGINE BOARD FRAME ASSEMBLY onto
the ENGINE BOARD. Press from the shown places to
lock it to its place.