Nokia E7-00 - Device Modes and Battery Optimization

Nokia E7-
00
RM-626
Service Manual Level 1&2
32 Confidential | Copyright © 2010 Nokia | All rights reserved Version 1.0
43) Finally press from shown place to lock the
remaining holder. Make sure that the cables are not
damaged while attaching the ENGINE BOARD FRAME
ASSEMBLY.
44) Place the ANTENNA FRAME ASSEMBLY as shown.
Press the ANTENNA FRAME ASSEMBLY to lock the
shown three clips. Be aware not to press from the
IHF ADHESIVE area marked with red rectangle.
45) Tighten the two TORX + size 4 screws to the
torque of 12 Ncm in the order shown.
46) Place the CAMERA MODULE with the tweezers as
shown. Make sure the CAMERA MODULE guiding is
aligned with the guiding in the camera gasket.
47) Press gently the CAMERA MODULE with the SS-93
to attach the camera retaining clips.
48) Open up the device. Connect the QWERTY
connector with the SS-93. Be careful not to damage
the connector.