EasyManua.ls Logo

Nokia FastMile 3 5G12-13W-A - Page 10

Nokia FastMile 3 5G12-13W-A
89 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Introduction
10
User Guide for Oceania
© 2022 Nokia. Nokia Confidential Information
Use subject to agreed restrictions on disclosure and use.
3TG-02288-AAAA-TCZZA-02
TheFastMile 5G Gateway 3 supports 5G NR and 4G LTE WAN connectivity. The
device is compliant with 3GPP Rel-15 standards. Actual throughputs will vary based
on aggregated bandwidths, network topology, network load, and radio conditions.
Your device can operate either in 5G NR or in 4G LTE. Where both 4G and 5G are
available, the FastMile 5G Gateway 3 supports dual connectivity EN-DC.
5G NR provides best download and upload speeds, thus improved user experience
for data services such as Internet browsing and video streaming. In case 5G NR
coverage is not available in your area, the device can also operate with 4G LTE only
as your WAN connection.
The FastMile 5G Gateway 3 provides the following features:
4G and 5G WAN connection
4G/LTE multi-band omni-directional antenna connectivity (up to 5dBi)
TEL port for voice service: TEL port may be blocked and unavailable to certain
providers
5G NSA/SA omni-directional antenna and high gain directional antenna
connectivity depending on 5G FR1 band (up to 11dBi)
5G NSA/SA WAN connectivity with omni and high gain antennas
self-contained integrated residential gateway
Nokia Wi-Fi connectivity:
- 4x4 IEEE 802.11ax 2.4 GHz (40 MHz) WLAN interface, with MU-MIMO
- 4x4 IEEE 802.11ax 5 GHz (80 MHz) WLAN interface, with MU-MIMO
- Wi-Fi 5 support (IEEE 802.11ac)
- Wi-Fi 6 support (IEEE 802.11ax) - dual band 4+4 connectivity
- backward compatible with 802.11a/b/g/n/ac
PIN-locked SIM cards: a SIM PIN number is required to unlock the SIM card and
a SIM PUK and PIN number are required to unblock the SIM card
one logical temperature sensor on IPQ and one logical temperature sensor on
the modem
supports WebUI configuration to enable or disable single SSID: if enabled the
CPE will merge 2.4 GHz band SSID and 5 GHz band SSID, and automatically
select the frequency band that provides a faster speed
can operate in the following modes:
- LTE-only
- LTE-5G EN-DC
- 5G SA

Table of Contents

Related product manuals