Mount in a car
13
2. Insert the catch on the mounting device
into the slot at the back of the
speakerphone (1). Rotate the
speakerphone clockwise until it locks into
place (2).
3. Peel off the protective sheet
from the adhesive side of the
pad (3), and press the pad
against the dashboard (4) so
that it stays firmly in place.
When you peel off the
protective sheet from the pad,
do not touch the adhesive
side.
4. Peel off the protective sheet from the other
side of the pad, and press the suction cup
on the mounting device against the pad (5).
5. Turn the speakerphone to the desired
position (6).
6. Rotate the mounting device clockwise to
create a vacuum (7). Check that the suction
cup is firmly attached.
To detach the speakerphone from the mounting device, rotate it
anticlockwise.
To detach the mounting device from the dashboard, rotate the
mounting device anticlockwise, and pull the strap located on the edge
of the suction cup.
To Next Page
Loading...
Need help?
General
