Training & Vendor Development
CMO Operations & Logistics
Multimedia Creation & Support CONFIDENTIAL
12.Dec.2006
18
Service Manual N71 RM-67/RM-112 Copyright © 2006 NOKIA Corporation. All rights reserved.
Approved 4.0
MGR
Page
(35)
33. The HINGE is fixed in the C-COVER. 34. Use the SS-15 as a support when removing the HINGE. Posi-
tion the HINGE exactly over the recess.
35. Use a Torx driver to push out the HINGE. Take special care to
the FLEX.
36. Now, the HINGE can be removed. Please note: This part must
not be reused.
37. Push up the BUSHING with a screwdriver. 38. Gently, separate the LID CENTER FRAME from the lower block.
39. Remove the SCREW CAPS with the SRT-6. Note: Do not reuse
the SCREW CAPS.
40. Unscrew the two, Torx Plus
®
size 5 SCREWS in the order
shown.
To Next Page
Loading...
