using this IAP, select the connection and Start web
browsing.
If you select a secured WLAN, you are asked to enter
the relevant password. To connect to a hidden
network, you must enter the correct network name
(service set identifier, SSID).
If you already have the web browser running using the
currently active WLAN connection, to return to the web
browser, select Continue web browsing. To end the
active connection, select the connection and
Disconnect WLAN.
Access points
Create a new access point
Select Menu > Settings and Connectivity >
Destinations.
You may receive access point settings in a message
from a service provider. Some or all access points may
be preset for your device by your service provider, and
you may not be able to change, create, edit, or remove
them.
When you open one of the access point groups (
,
, ), you can see the access point types:
indicates a protected access point
indicates a packet data access point
indicates a wireless LAN (WLAN) access point
Tip: You can create internet access points in a
WLAN with the WLAN wizard.
To create a new access point, select
Access point.
The device asks to check for available connections.
After the search, connections that are already available
are shown and can be shared by a new access point. If
you skip this step, you are asked to select a connection
method and to define the settings needed.
To edit the settings of an access point, open one of the
access point groups, and select an access point. Follow
the instructions from your service provider.
● Connection name — Enter a name for the
connection.
● Data bearer — Select the data connection type.
Depending on the data connection you select, only
certain setting fields are available. Fill in all fields
marked with Must be defined or with a red *. Other
fields can be left empty, unless your service provider
has instructed otherwise.
To use a data connection, your service provider must
support this feature, and if necessary, activate it for
your SIM card.
34
Connectivity
To Next Page
Loading...
