Section 2A: Your PCS Vision Phone - The Basics 18
Installing the Battery
To install the battery, replace the battery, or to access your phone’s
ESN (electronic serial number), you must first remove the phone
back cover.
To remove the back cover, turn the phone upside down, press the
release button down, and push the back cover away.
To install the LiIon battery:
1. Insert the battery (label side facing up) into the cavity at a
45-degree angle. (The metal contacts must be aligned with
and touching the metal prongs.)
2. Press down on the battery until it snaps into place.
Note:
Before removing the cover, always switch off the power and disconnect
the charger and any other device. Avoid touching electronic components
while changing the covers. Always store and use the device with the
covers attached.
To Next Page
Loading...
