RH-18/38 Company confidential
CCS Technical Documentation
Page 56 Nokia Corporation. Issue 1 10/03
Figure 54: TX power level tuning 3
1 Select Tx PA Mode low and tune the high lighted values.
2 The base level coefficient is taken from the high mode. Do not change it.
3 Calculate and select Stop
Figure 55: Stop TX power level tuning dialogue
If you are satisfied with the coefficients and the power, then save to the Permanent
memory.
You can also save the table to the PC, so that you can load it to an other phone. Or you
can select not to do anything by removing both ticks.
Only way to end the tuning session is with Yes
To Next Page
Loading...
