CCS Technical Documentation
Company confidential RH-18/38
Issue 1 10/03 Nokia Corporation. Page 61
RF control
This menu can be placed in maintenance or in tuning depending on the Phoenix.
It is meant to check the receiver or transmitter without going in call. It works very much
like a call, but you have control via the PC, and not via the tester.
The TX mode GSM900 can select between Free, High and low mode. It changes the PA
mode, but changes also the power level if a level is selected that is not supported in that
mode.
If you want to tune at other channels than the default, then you must select it first in RF
control and then start the tuning.
Figure 62: RF control window
To Next Page
Loading...
