Nokia RM-243 - WCDMA RX Chain Activation for Manual Measurement

WCDMA RX chain activation for manual measurement
Prerequisites
Make the following settings in Phoenix service software:
Setting WCDMA2100 WCDMA850
Phoenix Channel 10700 4408
Signal generator to antenna
connector
2141.0 MHz 882.6 MHz
Band I V
Steps
1. Via Phoenix Testing menu, choose WCDMA/RX Control.
2. In the RX control window, make the following settings:
3. Click Start to activate the settings.
If the settings are changed later on (for example, change of channel) you have to click Stop and Start
again.
Note: Clicking Stop also disables TX control if it was active.
4. Set the following RF generator settings:
RM-243
RF troubleshooting
Issue 1 COMPANY CONFIDENTIAL Page 4 –19
Copyright © 2007 Nokia. All rights reserved.