37
■ Cell broadcast messages
You may be able to receive messages, such as weather or traffic conditions from
your service provider (network service). To turn on the service, see Cell broadcast
in “Cell broadcast settings,” p. 40.
Select Menu > Messaging > Options > Cell broadcast.
A packet data connection may prevent cell broadcast reception.
■ Service commands
To enter and send service commands (also known as USSD commands) such as
activation commands for network services to your service provider, select Menu >
Messaging > Options > Service command. To send the command, select
Options > Send.
■ Messaging settings
Text message settings
Select Menu > Messaging > Options > Settings > Text message and from the
following options:
Message centres—lists all the defined message centers
Message centre in use —defines which message center is used for delivering text
messages and special message types such as business cards
Character encoding > Full support—to select all characters in the message to be
sent as viewed. If you select Reduced support, characters with accents and other
marks may be converted to other characters.
Receive report (network service)—When set to Yes, the status of the sent message
(Pending, Failed, Delivered) is shown in Reports.
Message validity—If the recipient of a message cannot be reached within the
validity period, the message is removed from the message service center. Note
that the network must support this feature.
Message sent as—to define how the message is sent. Default is Text.
Preferred connection—You can send text messages using the normal GSM network
or, if supported by the network, packet data.
To Next Page
Loading...
Need help?
General
