Edit a packet data access point
Select an access point group and access point marked with
. Follow the
instructions from your service provider.
Select from the following:
Access point name — The access point name is provided by your service provider.
User name — The user name may be needed to make a data connection, and is
usually provided by your service provider.
Prompt password — If you must enter the password every time you log in to a
server, or if you do not want to save your password in the device, select Yes.
Password — A password may be needed to make a data connection, and is usually
provided by your service provider.
Authentication — To always send your password encrypted, select Secure. To
send your password encrypted when possible, select Normal.
Homepage — Depending on the access point you are setting up, enter the web
address or the address of the multimedia message centre.
Use access point — Set the device to connect to the destination using this access
point after confirmation or automatically.
Modify advanced packet data access point settings
Select Options > Advanced settings.
Select from the following:
Network type — Select the internet protocol type to transfer data to and from
your device. The other settings depend on the selected network type.
Phone IP address (for IPv4 only) — Enter the IP address of your device.
148 Connectivity
© 2010 Nokia. All rights reserved.
To Next Page
Loading...
