The technical settings of the device (Mode, Ground Balance, Sensitivity, Threshold, and ID
Masking, Frequency) come with their factory default values at each startup. Personal
settings (Volume, Tone, Vibration, Brightness, and Language) come with the last adjusted
value when the device is turned o and on again.
You can customize and save your startup settings by following the steps below:
1. Go to the menu screen and be sure that all the options are at the desired setting.
2. Wait and exit the menu.
3. On the main screen, press and hold one of the up or down switches for at least 4 seconds.
The menu screen will appear; do not let go of the switch!
4. Keeping the switch pressed, press the '-' (minus) button. ''Please wait'' message will
appear on screen. You can let go of the switches.
5. Wait while the message is on screen. In about 4-6 seconds, the process will finish and the
menu screen will come up. It is normal for the device to emit dierent sounds during this
process.
6. Turn o and on the device again. Go to the menu to check whether your desired startup
settings are saved or not.
Changing the startup settings do not mean changing the factory default settings. You can
restore factory defaults at any time. This process is done the same way. The only dierence
is that you use the '+' switch instead of '-'
1. Be sure that you have exited the menu and you are in the main screen.
2. On the main screen, press and hold one of the up or down switches for at least 4 seconds.
The menu screen will appear; do not let go of the switch!
3. Keeping the switch pressed, press the '+' (plus) switch. ''Please wait'' message will appear
on screen. You can let go of the switches.
4. Wait while the message is on screen. In about 4-6 seconds, the process will finish and the
menu screen will come up. It is normal for the device to emit dierent sounds during this
process.
5. Turn o and on the device again. Go to the menu and be sure that the factory defaults
are restored.
FORS / Page 30www.noktadetectors.comNOKTA DETECTORS
FACTORY and STARTUP SETTINGS
To Next Page
Loading...
Need help?
General
