Nolan N-Com B3 - System Installation

B3
7
3. INSTALLATION
You can download the installation video from www.n-com.it N-Com / Download section.
Fig. 1
Fig. 2
Fig. 3
 Remove the “N-Com” protection plate
located on the helmet shell (Fig. 1) and
open the helmet chin guard (flip up
helmets).
 Remove the right and left cheek pads from
the helmet (see specific instructions
provided in the user manual of the helmet).
 Remove the Noise Reducers from the two
cheek pads, and tear off the pre-cut plastic
(if equipped).
Fig. 4 Fig. 5
Fig. 6
 Remove the back of the comfort padding
by pulling on the neck roll until it separates
from the shell (Fig. 4).
 Temporarily put the padding on the outside
of the helmet (Fig. 5).
 Remove the N-Com cover from the helmet
border gasket. Push from the inside of the
helmet to facilitate the removal (Fig. 6).