Need help?Do you have a question about the Norac UC4.5 and is the answer not in the manual?
Register your NORAC UC4.5 Spray Height Control System for warranty coverage.
Utilizes ultrasonic sensors for non-contact measurement, preventing boom damage.
System calibrates itself for optimal performance based on sprayer type.
Allows manual control of individual boom sections to avoid obstacles.
Sensors are designed by NORAC specifically for the agricultural industry.
Diagrams illustrating the components and connections of the UC4.5 system.
Ultrasonic sensors measuring distance to ground or crop canopy for height control.
Measure boom and sprayer roll dynamics for stability and control.
Measure boom suspension and cylinder position for enhanced control.
The main interface for operating and configuring the UC4.5 system.
Illustrates and describes the icons used on the control panel buttons.
Overview of system startup, run screen, and mode changing.
How sprayer switches affect system operation and boom control.
Configuration options for sensor modes, sensitivity, target height, and severe terrain.
Visual guide to navigating the UC4.5 control panel menus.
Situations where operator alert and manual override may be needed.
Terrain challenges affecting boom tip height and potential solutions.
Explanation of sensor modes for different ground and crop conditions.
Discusses the impact of sensor placement on performance and accuracy.
Details on sensor cleaning, operating range, and blanking distance.
Guides the user through system configuration and calibration for the sprayer.
Recalibrates system electronics to sprayer hydraulics after component changes.
Manual configuration of sensors and hydraulic parameters if automatic setup fails.
Installs typical values for calibration and geometry based on sprayer type.
Adds a center section sensor to improve system performance.
Additional sensors for improved boom protection in severe terrain.
Provides enhanced boom stability for loosely coupled sprayer systems.
Actively controls boom roll with wing tilt functions for better accuracy.
Lifts boom wings or entire boom for turning at field ends.
Allows automatic/manual mode switching or headland trigger via remote switches.
Alerts the operator if the valve block temperature exceeds 95° C.
Sounds an alarm if an ultrasonic sensor loses its reading.
Defines the lowest allowed height for a single wing sensor.
Allows switching between metric (cm) and imperial (inches) units.
Displays valve block and air temperatures.
Daily checks include greasing friction pads and sensor breakaway brackets.
Annual replacement of the hydraulic oil filter.
Procedure for cleaning sensor foam discs and transducers with water.
Addresses issues like booms not leveling, system not going auto, or resets.
Diagnoses 'NC', 'No Comm', 'NR', 'NoRdg' errors and 'I Absent' during startup.
Addresses issues with boom raise/lower, incorrect movement, and creeping.
Resolves issues with boom instability in auto mode or moving to the top in crop mode.
Explains messages like 'Timeout', 'Wiring!', 'Too Many', 'Bakwards', 'TooHigh!'.
Interprets messages like 'NR'/'NoRdg', 'Minimum Overide', 'Disabled', '>>>>>>>>>'.
General| Brand | Norac |
|---|---|
| Model | UC4.5 |
| Category | Paint Sprayer |
| Language | English |
To Next Page
