46
12.6 Operational Messages
The following messages may appear during normal operation and may not indicate an error
with the system.
"NR" or "NoRdg":
This indicates the sensor is not receiving a good reading. It is normal to see this message
occasionally, however if the message is constantly displayed there may be a problem with a
sensor. Refer to Section 12.2 for more information.
"Minimum Overide":
This message is displayed when the target height is lower than the Minimum Height Mode
allows.
"Disabled":
Access to the system setup features (Automatic Install, ReTune) has been disabled by the
installer to avoid unintentional system changes.
">>>>>>>>":
The control panel is busy with a task that may take a few seconds. Wait for the arrows to
disappear before activating any control panel switches.
To Next Page
Loading...
