30
ACTIVE ROLL SYSTEM:
Perform the Quick Install for the standard system as previously described.
Navigate to the "Roll ?" menu prompt in the SETUP ( ) menu. Press and then change
it to "Roll OnA" using the buttons. Press to confirm.
Navigate to the "Roll ?" menu prompt in the SENSOR DISPLAY menu. Select the
appropriate sensor serial number for the BF (boom frame) and IF (intermediate frame)
sensor. Press , and then set the "IFh" (intermediate frame height) and "BFh" (boom frame
height) to zero using the buttons. Press to confirm.
Perform a ReTune (Section 8.2).
BFh 0
IFh 0
Roll OnA
To Next Page
Loading...
