EN
136
Troubleshooting
The device is not working:
- Check that all connections are connected correctly.
- Check for a burned fuse.
No audio
- Check that the loudspeakers are connected correctly.
The device has "frozen”
- Turn off the device and restart it or disconnect it from the power
supply and reconnect it.
The device does not respond to any button pressing
- Turn off the device and restart it or disconnect it from the power
supply and reconnect it.
Weak reception or unavailable radio signal
- Check whether the antenna is connected and the quality
connection cable is not interrupted.
- The antenna is not long enough. Extend the length of the
antenna.
- The antenna is not thoroughly grounded. Thoroughly ground
the antenna.
No stereo signal reception
- Tune exactly to the required frequency.
- The signal is too weak, set to the MONO mode.
Remote control is not working
- Replace the battery in the remote control.
- Point the remote control at the remote control sensor on the
main unit.
- Clean the surface of the sensor.
To Next Page
Loading...
