NORAUTO START PRO - How to Jump Start Your Car; Jump Starting Procedure

63
HOW TO JUMP START YOUR CAR
WE STRONGLY SUGGEST TO VERIFY THE VOLTAGE OF THE CAR BATTERY IS 12V
BEFORE STARTING. IF IT IS BELOW 2V OR ABOVE 12.6V, IT CAN'T BE JUMP STARTED.
WARNING: When using this unit to start, make sure the positive and negative connections are correct,
otherwise the battery may explode.
1
Lig ht
Pow e r
Lig ht Pow er
READYOVERLOAD
TARGET
2
PSI KG/CM BAR
COOLING
LOWMI DDLEFULL
V
%
%
Setup
Unit
Inflator
TEST
M
Setup
Unit
Inflator
TEST
M
Seconds3
2
3
1 2
Press and hold the power switch (
8
) for
3 seconds to turn on the unit. Make sure the
battery level is over 50%.
Follow the steps below for jump start,
otherwise it could be dangerous:
1. Connect the red (+) clamp to the positive
(+) battery terminal.
2. Connect the black (-) clamp to the metal
part of the engine (negative ground) or to
the negative battery terminal.
3. Insert the jumper cable (
16
) into the jump
start port (
1
) of the device.
3
Lig ht Pow er
READY
V
Setup
Unit
Inflator
TEST
M
4
Lig ht
Pow er
READYOVERLOAD
TARGET
2
PSI KG/CM BAR
COOLING
LOWMIDDLEFULL
V
%
OFF
Setup
Unit
Inflator
TEST
M
3 Seconds
23
1
4
After the connection is completed,
“READY”on LCD indicate a correct status
to start jump start. Start the car and do not
crank over 5 seconds.
After the engine is successfully started,
first pull out the jump start plug
(16)
of the
device and then remove the clamps from the
car battery, and then long press the power
switch
(4)
to turn the unit off.