NORAUTO START PRO - How to Test the Battery; Battery Testing Procedure

64
HOW TO TEST THE BATTERY
1
Lig ht
Powe r
Lig ht Pow er
READYOVERLOAD
TARGET
2
PSI KG/CM BAR
COOLING
LOWMID DLEFULL
V
%
Setup
Unit
Inflator
TEST
M
Setup
Unit
Inflator
TEST
M
3 Seconds
2
Press and hold the power switch (
8
) for
3 seconds to turn on the unit.
Follow the steps below for jump start,
otherwise it could be dangerous:
1. Insert the jumper cable (
16
) into the jump
start port (
1
) of the device.
2. Connect the red (+) clamp to the positive
(+) battery terminal.
3. Connect the black (-) clamp to the metal
part of the engine (negative ground) or to
the negative battery terminal.
3
LOW
V
MIDDL E
V
FULL
V
Charge i mmediatel y OK GOOD
LCD LCDLCD
Check the battery status
Press “Battery test” button and the battery voltage
and status will show in the LCD.
Top on the
LCD
Battery range Result
LOW <11.7V Charge the battery
immediately or
replace the battery
MIDDLE 11.7≤V<12.5 Battery is ok and
charge if possible
FULL V≥12.5 Battery is good